Caveat: worth doing four times

I installed and uninstalled the new water pump (see yesterday’s blog entry) four times today, troubleshooting various leaks. On the forth install, it seems to be relatively leak-free, so Arthur and I decided to call it functional.
I enjoyed feeling competent to finally get it working.
But it was quite difficult and tiring, too. Out there in 32° weather banging on pipes:
1. Carry pump up to cistern shed.
2. Place pump on shelf. Attach hose, tighten clamps, repeat x 3 hoses. Bolt down pump. Test pump. Identify leaks.
3. Unbolt pump. Loosen clamps, remove hose, repeat x 3 hoses. Carry pump back down to workshop. Clean out threads, mess with fittings, reline all threads with teflon tape.
4. Go to step one.
Each loop takes about 2 hours.
picture

Back to Top